Learn to operate your interactive installation

A short course on running your interactive installation day to day (AI photo booth, interactive wall, projection).

What you'll need

  • The installation's devices and their remote control or control panel.
  • Control panel access: [TBD: control panel address and account]
  • About 30 minutes.

Part 1. Get to know the setup

  1. Review the device list: [TBD: device list — computer, screen/projector, camera, sensor, printer]
  2. Locate the power supply and internet connection.

Part 2. Switch on

  1. Turn on the power (power strip).
  2. Turn on the screen or projector.
  3. Turn on the computer and wait for the software to start automatically. [TBD: exact start-up order and wait time]
  4. Test it: take a test photo or touch the wall.
    Result: the installation is ready for visitors.

Part 3. While it's running

  • AI photo booth: keep the camera lens clean and the lighting sufficient. If there's a printer, check paper and ink. [TBD: how to replace paper and ink]
  • Interactive wall: keep the area in front of the sensor clear; if it responds slowly, see Part 5.
  • Projection: keep room lighting constant and the projector's vents unobstructed.
  • Visitor photos and data: how photos are stored and shared: [TBD: data storage and deletion policy]

Part 4. Switch off

  1. Close the software. [TBD: how to close the software]
  2. Shut down the computer from the system (Shut down), not by cutting power.
  3. Turn off the projector and wait for the fan to stop.
  4. Turn off the power last.
    Result: everything is shut down safely and will start without problems next time.

Part 5. If something isn't working

  1. Restart the software.
  2. If that doesn't help, restart the computer.
  3. Check the cables and internet connection.
  4. If the problem persists, submit a request under Application Support with High priority. Describe what isn't working and what you tried, and attach a photo or video.

Urgent help during an event: [TBD: on-site support contact procedure]

Check your progress

You've completed the course when you can:

  • switch the installation on and off in the right order;
  • run a test;
  • restart the software when something goes wrong.

Common mistakes

  • Cutting the power without shutting down the computer and projector first. This damages the equipment.
  • Moving devices or swapping cables. This can break the calibration.
  • Updating the software or system right before an event.

Related articles

ABOVE Digital – abovedigital.io